Test Calls - Matrix Telecom SIMADO GFX44 Quick Start Manual

Step 14: Default SE Password
It is very important to remember the SE password. It is advisable to note this
password at a safe place. However, if the SE password is forgotten or lost, it
can be set to its default value.
• To reset default Password, switch Off the system,
• Locate the mini jumper J9 on the main board.
• Put the jumper in A-B position.
• Switch on the system.
• Wait for 15 seconds.
• Switch Off the system.
• Restore the jumper in its original position (B-C).
• Switch it On again.
• SE password gets defaulted (1234).

Test Calls

You will need a cell-phone to make and receive the test call and an analog
phone to connect the FXS Port of SIMADO GFX44.
Making a call from FXS to Mobile
• Lift the handset of the analog phone connected to FXS Port (ANY) of SIMADO
GFX44.
• Dial the number of the cell-phone you are using for this test after you get the
dial tone.
• You will hear the Ring Back Tone (RBT) on analog phone and cell-phone
will also ring.
• Answer the call on cell-phone and talk.
• Replace the handset of analog phone to disconnect the call.