Sensitivity Setup; Aerial Flip Tips - UBSAN Q4 Instruction Manual

7 Sensitivity Setup

The nano Q4 can perform in 3 stages: low--middle--high
Click the elevator sticker to enter the 3 di erent stages:
The LED on the transmitter is Solid Green = the Q4 is in the low stage (about 30%
sensitivity)
The LED on the transmitter is blinking green = the Q4 is in the middle stage (about 60%
sensitivity)
The LED on the transmitter is blinking orange = the Q4 is in the high stage (about 100%
sensitivity)
Press (a)Elevator Trim /(b)Aileron Trim to change the sensitivity values and then hold
down the elevator stick for 1 second to con rm or exit. The Q4 will be more sensitive and
responsive with the correspondence values.

8 Aerial Flip Tips

The ip will only work in HIGH STAGE. press the elevator stick to switch into the High
Stage.
Press the Throttle stick to enter Flip Mode, indicated by two "beeps".
Press the Throttle stick again to exit Flip Mode, indicated by one "beep".
!
For proper ip execution, make sure the Q4 is close to level, within a 30°
angle with the ground, and add throttle to climb before you perform a ip.
MODE 2 MODE 1
9