AnyTone D868UV Firmware Update

Important Notice:
After update the firmware, you need to do the reset to the radio first, power off the radio
first. Then power it on while holding the PTT and the PF1 button below the PTT at the same time. The radio
will start up with a note on the display stating MCU Reset, Please Wait – and do not turn the radio off while it
restarts. ****** See the Separate FW Update Instructions for Details ******
.
Install the Customer Program Software (CPS) by running the D878UV_CPS_Setup_x.xx.exe setup

program in the CPS Program Folder
 After installing a new D878UV CPS version go to the top Menu -> Tool-> Options in the CPS to set
GPS, BT, 500 Hour Record and APRS options as needed
Please make sure the codeplug is saved to PC before your do the update and reset.
*** USB Drivers - Many users have found the D878 radio USB will connect in Windows 10 without
loading the AnyTone virtual drivers. The PC found Windows the driver that worked just by plugging in
and turning on the radio. If you get a new radio and your PC is Windows10 system, do not install the
GD32 virtual driver.
find the driver. *** If Windows 10 fails to load a USB driver please see the separate Virtual USB Driver
Installation Instructions.
D878UV --- Please use the firmware D878UV_Vx.xx for updating the radio.
D878UVII --- Please use the firmware D878UVII_Vx.xx for updating the radio.
D878UV firmware update V3.07 (dated 2025-4-29)
Change List
1. Resolve the issue that APRS doesn't work well.
2. Resolve the issue that GPS info menu was missing the Edit button.
3. Resolve the issue that Satellite Aos limit doesn't work.
4. Resolve the issue that when listen to a Satellite, the radio doesn't have a sound when SQ
set 0.
5. Resolve the issue that the radio doesn't display the satellite name after load the the
satellite information.
Firmware version: V3.07
CPS version: V3.07
ICON version: V1.23 （same, no need update）
SCT 3258 version: V2.01.07 BA （same, no need update）
BT Version: 10033 or 10036 or 10043 or 19043 (no need update)
D878UV firmware update V3.06 (dated 2025-1-23)
Change List
1. Add Maidenhead locator display in the GPS data, when the GPS is locked, the Maidenhead locator will
display under the Sat and Lat data.
2. Allows APRS Transmit under Satellite menu, press PTT+PF2 button to transmit the APRS. The APRS
shall be set up in CPS->Tool->GPS Satellite Data Update -> AprsTxFreq(Hz).
3. Allows Arm CTCSS transmit under Satellite menu, press PTT+PF1 button to transmit the ArmCTC or
DCS. The Arm CTC or Arm DCS shall be set up in CPS->Tool->GPS Satellite Data Update -> Arm CTC
*** Just plug the radio USB cable in to the USB port on your PC and let windows