Panasonic Urban Multi MX1 Series Manual page 28

Installation 1
WHEN ELECTRIC WIRING WORK IS FINISHED
Check drainage flow during COOL running, explained under "TEST OPERATION".
WHEN ELECTRIC WIRING WORK IS NOT FINISHED
Remove the electric parts box lid, connect a power supply and remote controller to the terminals.
Next, press the inspection/test operation button "
test operation mode. Press the operation mode selector button "
"
that the water has drained from the unit. Press "
Corner Type 1. Install the drain pipes.
(CS-DM)
28
". Then, press the ON/OFF button "
Note that the fan also starts rotating.
[Method of adding water]
Keep piping as short as possible and slope it downwards so that air may not remained trapped inside
the pipe.
Keep pipe size equal to or greater than that of the connecting pipe (Vinyl pipe of 25 mm nominal diam.
and 32 mm outer diam.).
Use the attached drain hose and clamp. Tighten the clamp firmly.
Insulate the clamp with the attached sealing pad.
Insulate the drain hose inside the building.
PACD011001G2 / PACD011004G3
" on the remote controller. The unit will engage the
". The indoor unit fan and drain pump will start up. Check
" to go back to the first mode.
Switch box
cover (1)
Switch box
cover (2)
P1 P2 F1 F2 T1 T2
Terminal board for
remote control (6P)
Urban Multi Inverter "MX1" Series
" until selecting FAN OPERATION
Power supply
terminal board (2P)
L
N
Power supply
Lead cable for remote control
3PA60996-10L