Honda UMK450T Manual page 70

62VL510X.book 2 ページ ２０１９年２月８日 金曜日 午後１時１１分
FRAME/THROTTLE
FRAME PIPE/THROTTLE
FRAME/THROTTLE
CABLE/GROUND CABLE
REMOVAL/INSTALLATION
REMOVAL
Remove the air cleaner cover (page 3-4).
Disconnect the engine stop switch connector [1].
Remove the screw/washer [2] and disconnect the
ground cable [3].
Loosen the throttle cable lock nut, and disconnect the
throttle cable [4] from the swivel [5].
Remove the screw/washer [1] and socket bolt [2].
Remove the frame pipe [3].
INSTALLATION
Check to see that the drive shaft spline [1] is not
damaged and apply oil to the spline.
Install the frame pipe [2] by aligning the driveshaft
spline and clutch outer spline [3].
Install the screw/washer [4] by aligning the screw hole
[5] of the frame pipe with screw hole of the engine
mounting bracket [6].
Tighten the screw/washer to the specified torque.
TORQUE: 4.2 N·m (0.43 kgf·m, 3.1 lbf·ft)
Install and tighten the socket bolt [7] to the specified
torque.
TORQUE: 6.1 N·m (0.62 kgf·m, 4.5 lbf·ft)
14-2
[4] [5]
[3]
[1]
[2]
[3]
[6]
[4]
[7]
[2]
[1]
[2]
[3]
[1]
[5]