Recoil Starter Pulley; Removal/Installation - Honda UMK450T Manual

62VL510X.book 5 ページ ２０１９年２月８日 金曜日 午後１時１１分
FLYWHEEL INSTALLATION
Clean tapered part of dirt, oil, grease and other foreign
material before installation.
Be sure to woodruff key is set in the key groove
properly.
Install the flywheel by aligning the key groove of the
flywheel with the key on the crankshaft.
Holding the flywheel with a commercially available strap
wrench [1], tighten the nut [2] to the specified torque.
TORQUE: 30 N·m (3.1 kgf·m, 22 lbf·ft)
Install the clutch (page 9-4).

RECOIL STARTER PULLEY

REMOVAL/INSTALLATION

Remove the following:
– Recoil starter (page 7-2)
– Clutch shoe (page 9-2)
Holding the flywheel with a commercially available strap
wrench [1], remove the recoil starter pulley [2] with a
screwdriver or equivalent tool [3].
[2]
[3]
CLUTCH
[1]
[1]
[2]
9-5