Table of Contents
Advertisement
M20011 REL-0000 (2103)
Leak Test
The Leak Test determines the leak rate in the system you are
monitoring.
The timeout setting for
automatically suspended during a Leak Test session.
Review or change the LEAK TEST DURATION setting
Starting from the
1.
Press the
screen.
2. If you want to change the duration, follow the on-screen
instructions
3.
✓ - Pressing the
TAP
4. Use the
first zero you want to change.
Note: The on-screen scrolling message reminds you to enter a
number from 0.1 - 1440 (1440 minutes is 24 hours).
5. Press the
and continue to use the
you have the total number of minutes you require.
6. You have three choices after entering minutes for duration:
1.
✓
Saves
2.
X Cancels
3.
0 Clears
7.
After reviewing or changing these settings, press the
Backward
Fix a RANGE ERR issue
1.
The first zero digit is blinking.
2. Press the
a valid number of minutes from 0.1 - 1440.
User Manual for Smart Manometer
Auto Off
(Automatic Shut Off) is
Home
screen:
Backward
key to view the
LEAK TEST DURATION TAP
Accept
key starts the first digit blinking.
Right Arrow
key to move the blinking cursor to the
Up Arrow
key until you see the number you need
Right Arrow
(the
Accept
key).
(the
Cancel
key).
to start over (the
key to go to the screen to start the Leak Test.
Zero
"0" key to reset all numbers to zeros and enter
Leak Test Duration
✓
TO CHANGE
and
Up Arrow
keys until
Zero
"0" key).
.
22 of 60
Advertisement
Table of Contents
