Toyota COROLLA Owner's Manual page 432

430
7-3. Do-it-yourself maintenance
■
Replacing the following bulbs
If any of the lights listed below has burnt out, have it replaced by
your Toyota dealer.
● Headlights (vehicles with LED headlights)
● Front position lights (vehicles with LED headlights)
● Side turn signal lights
● Tail lights
● High mounted stoplight
■
LED light bulbs
The headlights (vehicles with LED headlights), tail lights, high mounted stop-
light and front position lights (vehicles with LED headlights) consist of a num-
ber of LEDs. If any of the LEDs burn out, take your vehicle to your Toyota
dealer to have the light replaced.
■
Condensation build-up on the inside of the lens
Temporary condensation build-up on the inside of the headlight lens does not
indicate a malfunction.
Contact your Toyota dealer for more information in the following situations:
●Large drops of water have built up on the inside of the lens.
●Water has built up inside the headlight.
■
When replacing light bulbs
P. 418
WARNING
■
Replacing light bulbs
●
Turn off the lights. Do not attempt to replace the bulb immediately after
turning off the lights.
The bulbs become very hot and may cause burns.
●
Do not touch the glass portion of the light bulb with bare hands. When it is
unavoidable to hold the glass portion, use and hold with a clean dry cloth
to avoid getting moisture and oils on the bulb.
Also, if the bulb is scratched or dropped, it may blow out or crack.
●
Fully install light bulbs and any parts used to secure them. Failure to do so
may result in heat damage, fire, or water entering the headlight unit. This
may damage the headlights or cause condensation to build up on the lens.
■
To prevent damage or fire
Make sure bulbs are fully seated and locked.