Toyota COROLLA Owner's Manual page 199

Changing settings of the pre-collision system
■
Enabling/disabling the pre-collision system
Press the PCS switch for 3 sec-
onds or more.
The PCS warning light will turn
on and a message will be dis-
played in the multi-information
display, when the system is
turned off.
To enable the system, press the
PCS switch again.
The pre-collision
enabled each time the engine is
started.
* 1
: Vehicles with a 3-ring meter
* 2
: Vehicles with a 2-ring meter
■
Changing the pre-collision warning timing
Press the PCS switch to turn on the PCS activation indicator
display the current warning timing in the multi-information display.
Each time the PCS switch is pressed in the displayed state, the tim-
ing for the warning changes as follows:
If the operation timing setting has been changed, the setting will be
retained the next time the engine is started.
1
Far
The warning will begin to oper-
ate earlier than with the default
timing.
2 Middle
This is the default setting.
3 Near
The warning will begin to oper-
ate later than with the default
timing.
* 1
: Vehicles with a 3-ring meter
* 2
: Vehicles with a 2-ring meter
4-5. Toyota Safety Sense
system is
*
1
* 1
*
1
* 2
1
*
*
2
197
4
and