Installation - Electrolux EYE030S1WE User Manual

6 www.electrolux.com

3. INSTALLATION

3.1 Accessories
The appliance is supplied with the basic
equipment required for their installation
and Usage, such as:
• Safety valve.
This accessory is inside the packaging.
3.2 Placement
Both the wall on which the
water heater is to be
installed and the fixing wall
plugs and screws must hold
the weight of the appliance
full of water. If the wall is
very thin, back plates must
be used on the other side of
the wall. drill two holes on
the wall with size of 14mm
diameters and depth is
90mm.
WARNING!
Do not install the appliance
in the following places:
• Outdoors.
• Areas that are cold and freezing, the
freezing water may damage the
internal tank and pipes.
• Close to the ground.
• Where water discharge is not
possible.
The water heater can be placed
anywhere in the house. Nevertheless we
recommend placing it as near as
possible to the hot water tap, in order to
prevent temperature loss in the pipes.
90
mm
260 mm
Ø =14 mm
The appliance can be installed in all
bathroom sections except marked zones.
3.3 Hydraulic Installation
• Before starting connection to the
water distribution system, it is very
important to clean inlet pipes properly
to prevent metal or other particles
from getting into the heater body.
• Leave a minimum space of 40 cm
under the pipe outlet of the water
heater, to be able to gain access to
the electrical parts and to make
maintenance and repairing easier.
• If plastic pipes are being used, and in
order to carry out the installation
conditions, the pressure and
temperature conditions they are going
to undergo have to be taken into
account. A maximum pressure of 9
bars and maximum temperature of
70ºC, in normal conditions, or of
100ºC in abnormal conditions if the
safety thermostat switches off.
• In case of copper piping, connection
to the heater pipes must be made with
nonconductive sleeves to avoid
corrosion of piping (by direct contact
of iron and copper). Brass sleeve is
not permitted.
The water heater MUST be
installed with the safety
valve, which has a non-
return valve (supplied with
the water heater).