Suzuki GSX-R600 Manual page 104

12.Replace the drain plug gasket
with a new one. Reinstall the
drain plug and gasket. Tighten
the plug securely with a torque
wrench. Pour 2500 ml (2.6 US
qt) of new engine oil through
the filler hole and install the
filler cap. Be sure to always
use the specified engine oil
described
ENGINE OIL AND COOLANT
RECOMMENDATIONS
tion.
Drain plug tightening torque:
23 N·m (2.3 kgf-m, 16.5 lbf-ft)
NOTE: About 2200 ml (2.3 US qt)
of oil will be required when chang-
ing oil only.
NOTICE
Engine damage may occur if
you use oil that does not meet
Suzuki's specifications.
Be sure to use the oil specified
in the FUEL, ENGINE OIL AND
COOLANT
TIONS section.
in the FUEL,
sec-
RECOMMENDA-
13.Start the engine (while the
motorcycle is outside on level
ground) and allow it to idle for
three minutes.
14.Turn the engine off and wait
approximately three minutes.
Recheck the oil level on the
engine oil inspection window
while holding the motorcycle
vertically. If it is lower than the
"L" line, add oil until the oil level
is between the "L" line and the
"F" line. Inspect the area
around the drain plug and oil
filter for leaks.
NOTE: If you do not have a proper
oil filter wrench, have your Suzuki
dealer perform this service.
7-25