Page 1
SPARTAK ENTERPRISES, INC. FOLD DOWN DESK Model #1010-11WH LOT #1908 IF PARTS ARE MISSING AND OR DEFECTIVE, IF INSTRUCTIONS ARE NOT CLEAR OR IF YOU ARE EXPERIENCING PROBLEMS ASSEMBLING OUR PRODUCT. BEFORE YOU RETURN THE PRODUCT TO THE STORE, PLEASE CALL US TOLL FREE FOR CUSTOMER SERVICE ASSISTANCE...
Page 2
SPARTAK ENTERPRISES, INC. FOLD DOWN DESK Model #1010-33OA LOT #1909 IF PARTS ARE MISSING AND OR DEFECTIVE, IF INSTRUCTIONS ARE NOT CLEAR OR IF YOU ARE EXPERIENCING PROBLEMS ASSEMBLING OUR PRODUCT. BEFORE YOU RETURN THE PRODUCT TO THE STORE, PLEASE CALL US TOLL FREE FOR CUSTOMER SERVICE ASSISTANCE...
PARTS IDENTIFICATION NOTE: FIRST MAKE SURE THAT YOU HAVE ALL OF THE PARTS LISTED ON THIS SHEET. IF YOU ARE MISSING ANY PIECE(S), DO NOT ASSEMBLE THE UNIT. INSTEAD, CALL CUSTOMER SERVICE NUMBER AT: (888) 777-8250. WE WILL BE HAPPY TO ASSIST YOU. 1010A-Left front upright 1010H-Right rear upright 1010B-Back panel...
Page 5
We recommend you do one drawer at the time. The excess of glue can be wiped off with a damp cloth. Also, once glue sets it will turn translucent and it will not stick to laminated surface and can be easily peeled off. Press down Allow glue to set at least for 2 hours.
Page 7
Apply one drop of glue inside each of the dowel holes. Next, gently tap each dowel into place using a small hammer. DOWW830 CAMBT16 CAMBT16...
Page 8
Do not overtighten the screws as you may strip the wood. It will be a good idea not to use power drill. SPB1012BL NOTE: The center part of the hinge that sticks out should point up when you attach hinge in this step. Make sure lip on parts C and N is...
Page 9
Apply thick coat of glue in the grooves of parts H and J and one drop in each hole. The excess of glue can be wiped off with a damp cloth later. Also, once glue sets it will turn translucent and it will not stick to laminated surface and can be easily peeled off.
Page 10
Use block provided in hardware kit. Locking casters install in the front. UCHAN58 Make sure don't forget plastic spacer. Otherwise the screw puncher through the top. Also, you will be using the larger U-Channels in this step. SF1025BL UCHAN58 SP12PR...
Page 11
With six wood screws, attach the two part (K)'s together using the hinge. Make sure that the laminated edges are aligned as illustrated. SFH825A NOTE: The center part of the hinge that sticks out should point up when you attach hinge in this step. SFH825A Use block provided in hardware kit.
Page 12
With six wood screws, attach part (K) onto part (J), once again using a hinge. SFH825A...
Page 13
DOWM525 The purpose of the 2 Metal Pins on the Sliding Side is to prevent movement of Sliding Side under the Leaf. The U-Channel on the Leaf is meant to clamp down on the edge of the Leaf to prevent side-to-side movement .
Page 14
TRANSFORMATION INSTRUCTIONS First, lift the top panel slightly. (NOTE: Lift just enough so that the boards will not get damaged). Next, push side panel in. Make sure you push it in as far as it will go. Finally, gently let the top panel down. Voila!!!