Page 1
SPARTAK ENTERPRISES, INC. SWIVEL MEDIA TOWER Model #2385-21BL LOT# 2661 IF PARTS ARE MISSING AND OR DEFECTIVE, IF INSTRUCTIONS ARE NOT CLEAR OR IF YOU ARE EXPERIENCING PROBLEMS ASSEMBLING OUR PRODUCT. BEFORE YOU RETURN THE PRODUCT TO THE STORE, PLEASE CALL US TOLL FREE FOR CUSTOMER SERVICE ASSISTANCE...
Page 2
HARDWARE PART # DESCRIPTION CAMLOCK COVER CAP CCPZXX CAMLOCK CAMLT12 BOLT CAMBT12 BRACKET ANGLE BM25 EURO SCREW SPE610BL SHELF SUPPORT BPXX54 SWIVEL PLATE TRNTPL SWIVEL BOLT TRNTSC DOWW830 WOOD DOWEL TOOL REQUIRED PHILLIPS SCREWDRIVER HAMMER...
Page 3
NOTE: FIRST MAKE SURE THAT YOU HAVE ALL OF THE PARTS LISTED ON THIS SHEET. IF YOU ARE MISSING ANY PIECE(S), DO NOT ASSEMBLE THE UNIT. INSTEAD, CALL OUR CUSTOMER SERVICE NUMBER AT: (888) 777-8250. WE WILL BE HAPPY TO ASSIST YOU. 2385A-Top 2382D-Divider 4pcs...
Page 4
Do not tighten screw on the angle bracket all the way in this step. Leave it a bit loose until you attach part D in the next step. Then you will tighten the screws. CAMLT12 UNLOCKED POSITION Use small hole #4 from the left end.
Page 5
Press part (D) in the groove of part (E). The holes in part (D) should face away from part (E), except for holes where brackets are attched, and RED marked end of it should be on the same side as on part (E). Make sure part (E) and (D) are aligned with each other on both ends.
Page 7
Lock camlocks on panels E as you install them before you proceed to next one. Otherwise panels may fall over and cause damage. Make sure you have on top only RED marked ends of panels D & E Turn camlocks clockwise using flat (preferred) or phillips scrudriver until full stop(slightly over 1 2 a turn...
Page 8
First attach the top (A) and lock it in place. Next install one shelf in the middle using either hole#6 or 7, depending if you re going to use it for CDs or DVDs (see instruction at the botom of this page) on each side to restrict movement of inside dividers D.