Festool ISC 240 Li Original Instructions Manual page 19

► Turn the cutting set anti-clockwise by
approximately 30°.
► Remove the saw blade from the clamp­
ing sleeve.
8.3 Adjusting the cutting set with serrated
saw blade [5]
If the fixed saw blade can no longer be
positioned underneath the movable saw
blade, the adjusting levers [5-1] are worn. The
cutting set must be replaced.
Adjust the cutting sets with serrated saw blade
before initial operation. The movable saw blade
must be positioned above the fixed saw blade.
► Move the protective cover until the lower
adjusting lever [5-1] is free.
► Turn the adjusting lever until both saw
blades are level and parallel with one an­
other.
► Turn the adjusting lever clockwise by
one latching point.
The movable saw blade is positioned above the
fixed saw blade.
► Push the protective cover back.
► Carry out the same steps for the upper ad­
justing lever.
8.4 Changing the serrated saw blade [6]
► Disconnect the cutting set from the power
tool.
► Remove the protective cover.
Pull the movable saw blade [6-1] on the
►
single-cam shaft (T shaft) [6-2] away from
the guide rail at angle in order to remove it
from the guide rail.
► Raise the fixed saw blade [6-3].
► Pull the fixed saw blade out of the guide
rail.
► Push a new fixed saw blade into the
guide rail.
► Push the fixed saw blade downwards un­
til the recesses in the saw blade engage
with the protrusions of the adjusting levers.
► Hold a new movable saw blade against
the single-cam shaft (T shaft) and push the
end forwards into the guide rail at an angle.
The saw blade is hooked into the end of the
guide rail.
► Fit the protective cover.
8.5 Changing a cross-set saw blade
(accessory) [7]
► Disconnect the cutting set from the power
tool.
► Remove the protective cover.
Pull the movable saw blade [7-1] on the
►
single-cam shaft (T shaft) [7-2] away from
the guide rail at an angle in order to remove
it from the guide rail.
► Hold a new movable saw blade against
the single-cam shaft (T shaft) and push the
end forwards into the guide rail at an angle.
The saw blade is hooked into the end of the
guide rail.
► Fit the protective cover.
8.6 Fitting the base adapter [8]
► If necessary, push the extractor connec­
tor [3-1] upwards.
► Release the rotary knob by one turn.
► Slide the protective cover downwards by
approx. 4 cm.
Insert the base adapter [8-1] at the end
►
of the cutting set.
► Push the base adapter towards the pow­
er tool until it latches into it at the three
latching points [8-2].
► Close the rotary knob.
Make sure that the base adapter [8-1]
latches into the power tool at the three
latching points [8-2].
8.7 Removing the base adapter [9]
► Push the extractor connector [3-1] upwards
if required.
► Release the rotary knob by one turn.
► Release the base adapter at the three
latching points [9-1].
► Push the base adapter downwards and
away from the tool at an angle.
► Close the rotary knob.
8.8 Changing the guide rail slide [10]
Always use the guide rail slide [10-1] in
conjunction with a guide rail and only to­
gether with the cutting set with serrated saw
blade.
► Release the lever.
► Insert the cutting set.
► Close the lever.
► Remove the protective cover.
► Place the guide rail slide on the
grooves [10-2] provided in the guide rail.
Removal is performed in reverse order.
English
19