Accessories; Environment; General Information - Festool ISC 240 Li Original Instructions Manual

Follow the instructions enclosed with the
battery pack for service, maintenance,
disposal and transport of the battery pack.
10.1 Cleaning the lint filter [13]
To prevent the power tool from overheating, the
lint filter must be cleaned regularly on both
sides.
► Remove the lint filter.
► Extract dust from the lint filter.
► Insert the lint filter.

11 Accessories

The order numbers of the accessories and tools
can be found in the Festool catalogue or on the
Internet at "www.festool.com".
11.1 WA-ISC 240 angle stop
The WA-ISC 240 angle stop [14-1] is used to
saw flexible insulating materials with the FS/2
guide rail.
Fitting the angle stop on the guide rail [14]
The angle stop can only be fitted to the
side of the guide rail where the guide
spring [14-2] can engage in the guide
groove [14-3].
► Release the rotary knobs.
► Place the angle stop on the guide rail
and push it forwards until it is fully fitted on
the guide rail.
► Tighten the rotary knobs.
The angle stop is firmly seated in the guide.
Adjust the stop ruler [14-4].
►
Setting the angle [15]
► Release the rotary knob.
► Set the desired angle by using the point­
er.
► Tighten the rotary knob.
Move the angle stop into the transport posi­
tion. [16]
► Release the rotary knobs.
► Pull the angle stop out of the guide rail
by 5 cm.
► Turn the angle stop clockwise by 90°.
► Push the angle stop on the guide rail into
the transport position.
► Tighten the rotary knobs.
To move the angle stop back into the working
position, carry out the steps in reverse order.

12 Environment

Do not dispose of the device in the
household waste! Recycle devices, ac­
cessories and packaging. Observe appli­
cable national regulations.
EU only: In accordance with the European Di­
rective on waste electrical and electronic
equipment and implementation in national law,
used power tools must be collected separately
and handed in for environmentally friendly re­
cycling.
Information on REACH: www.festool.com/reach

13 General information

Imported into the UK by
Festool UK Ltd
1 Anglo Saxon Way
Bury St Edmunds
IP30 9XH
Great Britain
13.1 Bluetooth
®
The Bluetooth ® word mark and the logos are
registered trademarks of Bluetooth SIG, Inc.;
they are used by TTS Tooltechnic Systems AG &
Co. KG, and therefore by Festool, under licence.
English
21