Rangemaster Classic 60 User Manual page 22

Fig. 7.7
Catalytic Cleaning
Catalytic liners are installed within the oven cavity. These are
the matte-finished, light-coloured panels on the sides and/
or matte-finished panel at the rear of the oven. They work by
collecting any grease and oil residue during cooking.
The liner self-cleans by absorbing fats and oils and burning
them to ash, which can then be easily removed from the floor
of the oven with a damp cloth. The lining must be porous to
be effective. The liner may discolour with age.
If a large amount of fat is spilled onto the liner, it may reduce
its efficiency. To overcome this problem, set the oven to
maximum temperature for about 20 - 30 minutes. After the
oven has cooled, wipe out the floor of the oven.
Manual cleaning of the catalytic liners is not recommended.
Damage will occur if a soap-impregnated steel wool pad
or any other abrasives are used. In addition, we do not
recommend the use of aerosol cleaners on the liners. The
walls of a catalytic liner may become ineffective due to excess
grease. The excess grease can be removed with a soft cloth
or sponge soaked in hot water and the cleaning cycle can be
carried out as described above.
Removal of the Catalytic Liner
To remove the catalytic liner, remove the screws holding each
catalytic panel to the oven (Fig. 7.7).
Cleaning the Gas Hob
• Clean the gas hob on a regular basis.
• Take off the pan supports, caps and crowns of the hob
burners.
• Wipe the hob surface with a soft cloth soaked in soapy
water. Then, wipe the hob surface over again with a wet
cloth and dry it.
• Wash and rinse the hob-burner caps. Do not leave them
wet. Dry them immediately with a dry cloth.
• Make sure you re-assemble all parts correctly after
cleaning.
• The surfaces of the pan supports may become scratched
over time due to the use. This is not a production fault.
Do not use a metal sponge for cleaning any part of
n
the hob.
Make sure no water gets into the burners as this may
n
block the injectors.
Cleaning the Glass Parts
• Clean the glass parts of your appliance on a regular
basis.
• Use a glass cleaner to clean the inside and outside of the
glass parts. Then, rinse and dry them thoroughly with a
dry cloth.
19