Omron YSC-8361 Instruction Manual page 6

the data and return SN F2 interface.

How the Counter works: If sewn the number stitches more than the
number of stitches collected 90%, and the number of trimming times more
than collected, the counter add 1.

Clear Counter: press
5.7 Adjust the tacking

Adjusting of RVE.SOL action time
For start/end tacking or bar tacking, if unbalanced situation is appeared during natural
direction to reverse direction, please correct it as below:
parameter T01

Adjusting of RVE.SOL release time
For start/end tacking or bar tacking, if unbalanced situation is appeared during reverse
direction to natural direction, please correct it as below:
parameter T02
5.8 Quick functions on the keypad
Foot stroke
Start and end
strips
Position of the
needle
Stitch Length
Additional
thread tension
Decrease
Decrease
Figure 2：Keypad on the machine arm
Toggle foot stroke level
This key cancels the general setting for
sewing start and end strips. If strips are
activated, pressing the key disables the next
strip. If no strips are activated pressing the
key sews the next strip.
If the key is selected the needle moves to a
specific position. This position is determined
individually via the parameter settings, more
information read D15, D16
If this key is selected, the machine sews
using the smaller stitch length selected at
lower adjusting wheel for the stitch length
This key switches on the additional thread
tension
6
增大 T01
Increase
parameter T01
增大 T02
Decrease
parameter T02