Table of Contents
Advertisement
ENTER KEY
Press the scroll key for 4 seconds the display will enter the setup
menu. Press this key for 8 seconds to enter the calibration mode.
UP KEY
This key is used to increase the selected parameter value during the
lock indicator is off.
DOWN KEY
This key is used to decrease the selected parameter value during
the lock indicator is off.
RESET KEY
RESET
This key is used to:
1.Reset the limit condition after the process is within the limit.
2.Revert the display to the normal display.
3.Reset the latching alarm, once the alarm condition is removed.
4.Reset the limit annunciator.
Note:
If the RESET key is left pressed, only ONE reset operation will
occur. If the unit subsequently goes into a state where reset is
required again, the RESET key (or remote reset contacts) must be
released (opened) and pressed (closed) again.
UNLOCK KEY
Press the RESET key for 4 seconds to enable up/down key function,
also to reset the reference data (
will be extinguished. However, this function is disabled when remote
lock is selected for EIFN (Event input function).
LIMIT CONTROL
OP1
OP2
PV
HSP1
BRAINCHILD
Figure 1-2 Front Panel Display
8
4 seconds, 8 seconds
4 seconds
RESET
L91
LC
LF
LSP1
SP2 LOCK
RESET
UM0L911C
Section 3-13
) and the lock indicator
INDICATORS
Op1: Output 1 status indicator
OP2: Output 2 status indicator
LC: Degree C indicator
LF: Degree F indicator
PV: Process value
HSP1: High limit set point 1
LSP1: Low limit set point 1
SP2: Set point 2 for output 2
LOCK: Lock status indicator
See section 3-11
.
Advertisement
Table of Contents
