Table of Contents
Advertisement
Install both mounting clamps and insert the housing into panel
cutout.
45
Panel cutout
+0.5
45
_
0
2 - 3 Wiring Precautions
*
Before wiring, verify the label for correct model number and
options. Switch off the power when checking.
*
Care must be taken to ensure that maximum voltage rating
specified on the label are not exceeded.
It is recommended that power of these units to be protected
*
by fuses or circuit breakers rated at the minimum value
possible.
*
All units should be installed inside a suitably grounded
metal enclosure to prevent live parts being accessible from
human hands and metal tools.
*
All wiring must conform to appropriate standards of good
practice and local codes and regulations. Wiring must be
suitable for maximum voltage, current, and temperature
rating of the system.
*
Take care not to over-tighten the terminal screws.
+0.5
_
0
Figure 2-1 Mounting Diagram
UM0L911C
Panel
86 mm
94 mm
23
Advertisement
Table of Contents
