Preparation - HIKVISION DS-2TD6267-75C4L/W Quick Start Manual

DS-2TD6267-75C4L/W Thermal Bi-Spectrum Network Positioning System Quick Start Guide

1 Preparation

Basic Requirement
All the electronic operation should be strictly compliance with the electrical safety regulations, fire
prevention regulations, and other related regulations in your local region.
Check the package contents, and make sure that the device in the package is in good condition and all
the assembly parts are included.
Use the system according to the working environment requirement.
Checking Installing Environment
Be sure that there is enough space to install the positioning system and accessories.
Make sure that the wall is strong enough to withstand at least eight times the weight of the system and
the mount.
Preparing Cables
According to the actual network bandwidth, Cat 5 (in 100M) or Cat 6 (100M above) is needed.
When the Positioning System uses standard 24 VAC power supply, the power cable should be American
wire gauge 18 or above. The formula of the cross-section S (mm²) and the maximum transmission distance
L (m) of the bare wire is L=50*S.
Choose the video cable according to the transmission length. The video should meet the least demands
as: 75Ω resistance; 100% copper core conducting wire; 95% weaving copper shield.
RS-485 communication cable, refer to Appendix.
24 VAC power cable, refer to Appendix.
Preparing Tools
Before installation, prepare the tools needed such as expansion screws, electric hammer, electric drill,
wrench, screwdriver, electroprobe, and network cable.
Original Packaging
When you unpack the positioning system, keep the original packaging properly. In case returning or
repairing the positioning system, pack the positioning system with the original packaging.
NOTE:
The user is responsible for any damage caused when transporting with non-original
packaging.
QSG DS-2TD6267-75C4L/W 041921NA 6