Finishing Installing; Setting System Over A Lan; Wiring; Activating The System - HIKVISION DS-2TD6267-75C4L/W Quick Start Manual

DS-2TD6267-75C4L/W Thermal Bi-Spectrum Network Positioning System Quick Start Guide
3. Connect the corresponding required cables and power on. Make sure the system functions, e.g., live
view and control operations work normally.
3.5

Finishing Installing

NOTE:
Connect the corresponding cables and turn the power on; the system perform a self-
test automatically. Make sure the live view image and the PTZ controls work normally,
and then finish the installation.

4 Setting System over a LAN

You shall acknowledge that the use of the product with Internet access might be under network
•
security risks. To avoid network attacks and information leakage, strengthen your protection. If the
product does not work properly, contact your dealer or the nearest service center.
To ensure the network security of the positioning system, we recommend you to have the system
•
assessed and maintained termly. Contact us if you need such service.
4.1

Wiring

To view and configure the system via a LAN (Local Area Network), connect the network system in the same
subnet as your PC. Then, install the SADP or client software to search and change the network system's IP
address.
The following figure shows the network system's cable connections.
4.2

Activating the System

Purpose
You must activate the system by setting a strong password for it before you can use the system.
Activation via Web browser, activation via SADP, and activation via client software are supported. In the
following sections, activation via Web browser and SADP will be taken as examples. Refer to the system
user manual for details of activation via client software.
QSG DS-2TD6267-75C4L/W 041921NA
Figure 14, Install the Positioning System
Figure 15, Wiring over LAN
16