Connecting Icp Expert Software To The Icp-Oes; Performing A Detector And Instrument Calibration - Agilent Technologies 5100 ICP-OES User Manual

Installation
For instructions on how to install your ICP Expert software, refer
to the documentation provided with your software:


Once you have installed the appropriate software, connect the
Ethernet cable, set the instrument IP address if necessary, and then
perform the Detector Calibration and Wavelength Calibration.

Connecting ICP Expert software to the ICP-OES

To connect the software and instrument:
1
2
3
4
5
6

Performing a Detector and Instrument Calibration

To perform a detector and wavelength calibration:
1
2
3
4
30
ICP Expert Software Installation Instructions
ICP Expert Software Installation Instructions for 21 CFR Part 11
Environments
Start the ICP Expert software by double-clicking on the desktop
icon.
Click Instrument.
Click Connect.
Enter the IP address of the instrument or select an existing
instrument.
Click Connect.
Click Close.
Turn on the external exhaust.
Start the ICP Expert software and open the Instrument Window.
Connect the software to the instrument, if needed.
a
Click Instrument in the ICP Expert toolbar.
b
Click Connect.
c
Select the instrument from the list and the click Connect.
Click Calibrate in the 'Detector' section.
Agilent 5100 and 5110 ICP-OES User's Guide