Toshiba MD-0101 Service Manual page 23

9. Detach stop ring, remove 2 bushings, and re-
move ADU feed roller shaft middle.
[I] ADU feed roller shaft lower/clutch 08S018-06CL
1. Detach ADU hinge cover F. (See Fig. 6-1)
2. Detach ADU hinge cover R. (See Fig. 6-2)
3. Remove ADU paper guide assembly.
(See Fig. 6-3 and 6-4)
4. Remove ADU. (See Fig. 6-5 to 6-9)
5. Detach ADU cover. (See Fig. 6-10 to 6-12)
6. Detach PWB cover. (See Fig. 6-13)
7. Remove timing belt. (See Fig. 6-21)
8. Detach one connector from ADU PWA (CN215).
9. Remove 4 screws, release one clamp, and re-
move ADU motor bracket lower.
10. Detach the E-ring, remove clutch 08S018-06CL
and 2 bushings, and remove ADU feed roller
shaft lower.
October 2000 © TOSHIBA TEC
Stop ring
Bushing
ADU PWA
CN215
Clamp
Harness
Clutch 08S018-06CL
Bushing
E-ring
6 - 7 MD-0101 DISASSEMBLY AND REPLACEMENT
ADU feed roller
shaft middle
Fig. 6-22
ADU motor
bracket lower
Connector
Fig. 6-23
ADU feed roller
shaft lower
ADU feed roller
shaft lower
Fig. 6-24
Bushing
242
Screw
243
Bushing
244