Toshiba MD-0101 Service Manual page 20

[E] ADU PWA
1. Detach ADU hinge cover F. (See Fig. 6-1)
2. Detach ADU hinge cover R. (See Fig. 6-2)
3. Remove ADU. (See Fig. 6-5 to 6-9)
4. Detach ADU cover. (See Fig. 6-10 to 6-12)
5. Remove 4 screws, release the harness from the
clamp, and detach PWA cover.
6. Detach all the connectors from ADU PWA, re-
lease 4 locking supports, and remove ADU
PWA.
[F] ADU motor
1. Detach ADU hinge cover F. (See Fig. 6-1)
2. Detach ADU hinge cover R. (See Fig. 6-2)
3. Remove ADU. (See Fig. 6-5 to 6-9)
4. Detach ADU cover. (See Fig. 6-10 to 6-12)
5. Detach one connector from ADU PWA (CN216),
remove 2 screws, remove ADU motor by sliding
in the direction of the arrow.
Note: Apply 0.1g of GREASE (X5-6020) to the
gear tooth surface.
MD-0101 DISASSEMBLY AND REPLACEMENT
Screw
Screw
Locking support
ADU motor
Screw
6 - 4
Clamp
PWA cover
Clamp
Fig. 6-13
ADU PWA
Fig. 6-14
CN216
ADU motor
Connector
Fig. 6-15
October 2000 © TOSHIBA TEC
234
235
236-1