Common Failures And Solutions - Ducati Corse AIR User Manual

The display board is working but the motor doesn't work
Reason Analysis
The break handle is damaged
The speed regulating steering
handle is damaged
The motor is damaged
Charging doesn't work
Reason Analysis
The battery charging port is
loose
The connection of the charger
plug is not well
Can't turn on the scooter
Reason Analysis
The battery is dead
The power button is out of
order

6. Common Failures and Solutions

Solutions
Pull out the socket of the break handle (normally open type brake
handle), if the motor works, then it is the failure of break handle, should
replace the break handle.
Firstly check the speed regulating steering handle and motor's hall
switch are short circuit or not. Generally it is easier to cause the joint
short circuit after rain affected with damp, so notice the short circuit of
steering handle and the motor hall switch. Otherwise there will be a
continuous damage of the replacement controller!
If the motor doesn't work turn, please inspect the motor's hall switch
and turning handle's signal. Once the power-on, the controller shall be
very hot, generally it is short circuit of the controller internal power
tube, should immediately cut off the power.
Solutions
Change a good charging port
Change a good charger connector
Solutions
Charge the scooter for 1-2 hours according to the user manual.
Check the power button which has got stuck or not.
13