Configuration Of Device; Setup Program Connection - SECURECOM SC-GPRS Manual

4.

Configuration of device

Connect the device with USB cable to a windows PC (Compatibility: Windows 7, 8.1, and 10), and a new
drive will be installed. When connected to that machine for first time, the driver will be installed first,
then the new drive will be found. This drive is the flash memory of SC-GPRS device, and contains the
software and this manual. You can run the software from device, or copy it to your PC and run it from
there. When the device is powered through terminals, the USB cable can be plugged or unplugged at
any time, it will not affect the device. The windows machine might require a proper closing of USB
connection before unplugging the cable.

4.1. Setup program connection

If the device is password protected or a wrong type of device is connected on USB port, the PASSWORD
field is displayed. If a wrong password is entered, the software will display the status fields only Settings
are not displayed and can not be changed. This mechanism prevents unauthorized access to device
settings.
As the software successfully connects to the device, it reads out the device and shows the status, device
version and actual settings in device (marked red on following picture):
In case that software does not show a "connected" status or the firmware version, the USB connection
was not made properly. Please select a different USB port check the USB cable. If the problem persist,
the device USB driver might be in conflict with some other driver in windows, restart the windows or try
the connection on another machine.
SC-GPRS 6 EN
Alarm Monitoring Communicator v1.3