Parameters Setting By Sms Messages - SECURECOM SC-GPRS Manual

6.

Parameters setting by SMS messages

Informations about the device and changes of the most important settings can be sent through SMS.
The format of the message should be:
parameter=value*
More commands can be sent in one message, but every command must finish with character *
(therefore, the message also must finish with this character)
parameter1=value1*parameter2=value2*...
For example: APN=internet*IP1=82.65.128.185*
Here is the list of parameters that can be changed with explanation for the name:
INFOSMS: Phone number to which the incoming messages will be forwarded
APN: apn
USR: username (for the APN)
PWD: password ( for the APN)
IP1: IP adress of the MS1 receiver
PORT1: receiving port of the MS1 receiver
IP2: IP adress of the MS2 receiver
PORT2: receiving port of the MS2 receiver
The RESET command is special, it can not be combined with other commands, therefore the message for
reset must be like this:
RESET*
You can also request the status information from the device, with following command:
?*
The device will reply with a SMS message that contains the information, in following format:
SIGNAL: 21
GPRS: OK
MS1: OK
MS2: ERROR
( These values are EXAMPLE)
SC-GPRS
Alarm Monitoring Communicator v1.3
11 EN