Zanussi ZOB38903 User Manual page 16

• Clean all oven accessories after each use
and let them dry. Use a soft cloth with warm
water and a cleaning agent.
• If you have nonstick accessories, do not
clean them using aggressive agents, sharp-
edged objects or a dishwasher. It can de-
stroy nonstick coating.
Stainless steel or aluminium applian-
ces:
Clean the oven door with a wet sponge only.
Dry it with a soft cloth.
Do not use steel wool, acids or abrasive materi-
als, as they can cause damage to the oven sur-
face. Clean the oven control panel with the
same precautions.
Cleaning the door gasket
• Regularly do a check of the door gasket. The
door gasket is around the frame of the oven
cavity. Do not use the appliance if the door
gasket is damaged. Contact the Service
Centre.
• To clean the door gasket, refer to the general
information about cleaning.
Shelf supports
You can remove the shelf supports to clean the
side walls.
Removing the shelf supports
1
Pull the front of
the shelf support
away from the side
wall.
Installing the shelf supports
Install the shelf supports in the opposite se-
quence.
16
2
1
2
Pull the rear end
of the shelf support
away from the side
wall and remove it.
The rounded ends of the shelf supports
must point to the front.
Aqua cleaning
The Aqua cleaning procedure uses steam to
help remove remaining fat and food particles
from the oven.
1. Put 300 ml of water into the Aqua cleaning
container at the bottom of the oven.
2. Set the oven function
3. Set the temperature to 90 °C.
4. Let the appliance operate for 30 minutes.
5. Deactivate the appliance and let it cool
down.
6. When the appliance is cool, clean the inner
surfaces of the oven with a cloth.
Warning! Make sure that the appliance is
cool before you touch it. There is a risk of
burns.
Oven lamp
Warning! Be careful when you change
the oven lamp. There is a risk of electrical
shock.
Before you change the oven lamp:
• Deactivate the oven.
• Remove the fuses in the fuse box or deacti-
vate the circuit breaker.
Put a cloth on the bottom of the oven to
prevent damage to the oven light and
glass cover.
Always hold the halogen lamp with a cloth to
prevent grease residue from burning on the
lamp.
1. Turn the glass cover counterclockwise to
remove it.
2. Clean the glass cover.
3. Replace the oven light bulb with an appli-
cable 300 °C heat-resistant oven light
bulb.
Use the same oven lamp type.
4. Install the glass cover.
.
www.zanussi.com