1.1 Copyright Notice While all information contained herein have been carefully checked to assure its accuracy in technical details and printing, Vantron assumes no responsibility resulting from any error or features of this manual, or from improper uses of this manual or the software. Please contact our technical department for relevant operation solutions if there is any problem that cannot be solved according to this manual.
1.5 Limitation of Liability/Non-warranty For direct or indirect damage to this device or other devices of Vantron caused by failure of conforming to this manual or the safety instructions on device label, Vantron assumes neither warranty nor legal liability even if the device is still under warranty.
Proper power source only Start only with power source that satisfies voltage label and the voltage necessary according to this manual. Please contact technical support personnel of Vantron for any uncertainty about the requirements of necessary power source. 7 / 28...
Do not try cleaning exposed electronic components unless with a dust collector. Support for special fault: Power off and contact technical support personnel of Vantron in case of the following faults: The device is damaged. The temperature is excessively high.
Overview 2.1 Introduction Thank you for choosing Vantron. It is our commitment to provide our valued customers with the embedded devices equipped with the state-of-the-art technology and the best product services. Vantron’s VT-M2M-BTA-DE-A is based on the most advanced ARM and Intel Atom processors and has low-power consumption and high integration.
2.2.2 Ordering Information Order Examples: ATOM Baytrail single Processor, 2GB DDR3L, 16GB SSD, 4G, WiFi, VT-M2M-BTA-DE-A-S-2GM-16GF- mCARD, extended temperature GWM-I 10 / 28...
3.3 Interface Description 3.3.1 Wide-Range Power Interface Power JACK with lock Description DGND (ground pin) Power (+12 DC,UP to 36V) 3.3.2 Ethernet Interface Standard RJ45 interface, supporting 10M/100M/1000M self-adaptation, this is a standard RJ45 ethernet port. 15 / 28...
3.3.5 USB Host Connector Dual vertical USB A type interface, USB2.0 Description USB1_VCC(+5VDC) USB1_D- USB1_D+ USB1_DGND(ground pin) USB2_VCC(+5VDC) USB2_D- USB2_D+ USB2_DGND(ground pin) Notes: Insert external device in USB1 connector should before powering 19 / 28...
Page 20
3.4 Operation Notice 3.4.1 Change SIM Card Push the small button on the left of SIM Card Holder, and install the SIM card to the holder. Then push the holder into the Slot. 3.4.2 Power Supply Please make sure using adapter in the accessory, or the power is not reversed when powered by other adapter.
Page 21
Tips Waste Disposal It is recommended to disassemble the device before abandoning it in conformity with local regulations. Please ensure that the abandoned batteries are disposed according to local regulations on waste disposal. Do not throw batteries into fire (explosive) or put in common waste canister.
Page 22
In the aim of avoiding accidents as far as possible, it is not allowed to replace the system or change components unless with permission and certification. Please contact the technical department of Vantron or local branches for help. Pay attention to caution signs.
Page 23
Vantron reserves the right to make necessary changes to this manual without prior notice. No part of this manual may be reprinted or publicly released in forms of photocopy, tape, broadcast, e-document, etc.
Page 24
Any modification to the product is not permitted unless authorized by Vantron. It’s not allowed to disassemble the product. It is not allowed to replace the system or change components unless with permission and certification. Please contact the technical support department of Vantron or local branches for help.
Page 25
ISED statement This radio transmitter [IC:11152A-BTADEALP] has been approved by Innovation, Science and Economic Development Canada to operate with the antenna types listed below, with the maximum permissible gain indicated. Antenna types not included in this list that have a gain greater than the maximum gain indicated for any type listed are strictly prohibited for use with this device.
Page 26
(1710-2700MHz) 3.0 dBi (698-960MHz) Asian Creation AC-Q7027-YZW SMA(Male) Monopole Diversity 5.0 dBi (1710-2700MHz) Shenzhen Norminson NP002 28dBi SMA(Male) Monopole Technology CO., LTD. This device complies with Innovation, Science and Economic Development Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
Page 27
provide instructions and the antenna used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operation in conjunction with any other antenna or transmitter. End-users and installers must be provide with antenna installation instructions and transmitter operating conditions for satisfying RF exposure compliance.
Page 28
US Office: Vantron Technology, Inc. Address: 440 Boulder Court, Suite 300, Pleasanton, CA 94566 Tel: +1 916-202-7042 Email: sales@vantrontech.com China Office: Chengdu Vantron Technology, Ltd. Address: No.5 GaoPeng Road, Hi-Tech Zone, Chengdu, SiChuan, P.R. China 610045 Tel: 86-28-8512-3930/3931, 8515-7572/6320 Email: sales@vantrontech.com.cn 28 / 28...
Need help?
Do you have a question about the VT-M2M-BTA-DE-A and is the answer not in the manual?
Questions and answers