Related Manuals for Vantron FPC-N64
Summary of Contents for Vantron FPC-N64
- Page 1 FPC-N64 User Manual M2M Gateway Product Version: 1.0 Date: 2019-11-02 For any question, please contact Chengdu Vantron Technology, Ltd. Copyright © Vantron Technology, Ltd. All rights reserved.
- Page 2 Change History This document describes FPC-N64 briefly and is intended for all readers. This table describes the version and release date. Version Description Date Author V1.0 First release. 2019-11-02 Guomin Zhang...
- Page 3 Vantron reserves all rights of this manual, including the right to change the content, form, product features, and specifications contained herein at any time without prior written notice.
- Page 4 Limitation of Liability/Non-warranty For direct or indirect damage to this device or other devices of Vantron caused by failure of conforming to this manual or the safety instructions on device label, Vantron assumes neither warranty nor legal liability even if the device is still under warranty.
- Page 5 Use Proper power source only. Start only with power source that satisfies voltage label and the voltage necessary according to this manual. Please contact technical support personnel of Vantron for any uncertainty about the requirements of necessary power source. Use tested power source. This product still contains a button lithium...
-
Page 6: Table Of Contents
Contents 1. Overview ..................... 1 1.1 Introduction ..................1 1.2 Specifications/Features ..............2 2. FPC-N64 Hardware Instructions ............. 3 2.1 Product Appearance ................3 2.2 Interface Description ................4 2.2.1 Power Interface ..............4 2.2.2 Ethernet Interface ..............4 2.2.3 RS232 or RS485 Connector ..........5 2.2.4 RS485 Connector .............. -
Page 7: Overview
FPC-N64 User Manual 1. Overview 1.1 Introduction Thank you for choosing Vantron. It is our commitment to provide our valued customers with the embedded devices equipped with the state-of-the-art technology and the best product services. Vantron’s M2M products are based on the most advanced ARM and Intel Atom processors and have low-power consumption and high integration. -
Page 8: Specifications/Features
FPC-N64 User Manual 1.2 Specifications/Features Table 1-1 describes specifications. Table 1-1 Specifications TI, AM3352, ARM Cortex-A8, 32-Bit, 1 GHz Processor Low Power Processor On Board RAM DDR3, 256 MB Memory Flash 1 GB Wireless Bluetooth OPT Bluetooth V4.0, 2.4 GHz Internal Antenna... -
Page 9: Fpc-N64 Hardware Instructions
FPC-N64 User Manual 2. FPC-N64 Hardware Instructions 2.1 Product Appearance Figure 2-1 Front view Figure 2-2 Side view (right) Figure 2-3 Side view (left) -
Page 10: Interface Description
FPC-N64 User Manual 2.2 Interface Description 2.2.1 Power Interface Figure 2-4 Power connector outlook Pin 1 Table 2-2 Pin description of power connector Description Power input range: DC9-30V or AC24V L DC Ground or AC24V N Shell ground 2.2.2 Ethernet Interface Standard RJ45 interface, supporting 100M Full/Half Duplex, is a standard RJ45 Ethernet port. -
Page 11: Rs232 Or Rs485 Connector
FPC-N64 User Manual 2.2.3 RS232 or RS485 Connector Standard vertical 1 x 3 x 3.81 mm male Terminal Block Figure 2-6 RS232 or RS485 connector Table 2-3 Pin description of RS232 or RS485 connector Description Remarks TX or RS485_A RX or RS485_B... -
Page 12: Rs485 Connector
FPC-N64 User Manual Table 2-4 Bit description of RS232 or RS485 connector Description Single ON: Have matched with a resistor of 120 ohm Term OFF: No ON: Have pulled up a resistor of 510 ohm Bias- OFF: No ON: Have pulled down a resistor of 510 ohm... -
Page 13: Boot Configuration
FPC-N64 User Manual Figure 2-9 DIP Switch for selection Table 2-6 Bit description of RS485 connector Description Single ON: Have matched with a resistor of 120 ohm Term OFF: No ON: Have pulled up a resistor of 510 ohm Bias-... -
Page 14: Led
FPC-N64 User Manual 2.2.6 LED PWR LED: If the light is on, the system is successfully started; If the light is off, the system is turned off. ERR LED: User can define by themselves. SS LED: User can define by themselves. -
Page 15: Renew Button
FPC-N64 User Manual TTL_TXD TTL_RXD DGND 2.2.8 Renew Button Renew button: Press and hold this button to restore factory settings, and the press time is user-defined. Figure 2-13 Renew button 2.2.9 SD/MMC Socket This is standard SD card socket where user can save data on this storage. -
Page 16: Tips
Unauthorized changes to this product or its components are prohibited. In the aim of avoiding accidents as far as possible, it is not allowed to replace the system or change components unless with permission and certification. Please contact the technical department of Vantron or local branches for help. - Page 17 Vantron assumes no responsibility of possible missing contents and information, errors in contents, citations, examples, and source programs. Vantron reserves the right to make necessary changes to this manual without prior notice. No part of this manual may be reprinted or publicly released in for FCC Warning FCC Supplier’s Declaration of Conformity...
- Page 18 —Consultez le concessionnaire ou un technicien expérimenté en radio/télévision pour obtenir de l’aide. Any modification to the product is not permitted unless authorized by Vantron. It’s not allowed to disassemble the product, it is not allowed to replace the system or change components unless with permission and certification. Please contact the technical support department of Vantron or local branches for help.
- Page 19 FPC-N64 User Manual IC statement This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions: 1. This device may not cause interference. 2. This device must accept any interference, including interference that may cause undesired operation of the device.
- Page 20 FPC-N64 User Manual compliance. Cet équipement doit être installé et actionné conformément aux instructions et l’antenne utilisée pour cet émetteur doit être installée pour fournir une distance de séparation d’au moins 20 cm de toutes les personnes et ne doit pas être co-localisée ou exploitée en conjonction avec toute autre antenne ou émetteur.
-
Page 21: Appendix A: How To Contact Us
Address: 440 Boulder Court, Suite 300, Pleasanton, CA 94566, USA Tel: 925-621-8758 Email: sales@vantrontech.com China Office: Chengdu Vantron Technology, Ltd Address: 6th Floor, 1st Building, No.9, 3rd Wu Ke East Street, Wu Hou District, Chengdu 610045, China Tel: 86-28-8512-3930/3931, 8515-7572/6320 Email:...
Need help?
Do you have a question about the FPC-N64 and is the answer not in the manual?
Questions and answers