Troubleshooting; Cleaning The Drain Pump - Proline FP 812 Operating Instructions Manual

GB

Cleaning the drain pump

Drain the water out of the machine and then clean the drain pump.
Please inspect and clean the drain pump regularly.
Never remove the pump cover during a wash cycle. When replacing the pump cover,
ensure it is securely tightened so as to stop leaks.

TROUBLESHOOTING

Problems
The washing machine
will not start.
The door does not open.
Detergent remains in the
detergent drawer after
the programme is
complete.
Washing machine
vibrates or is too noisy.
The washing machine
does not drain and/or
spin.
The washing result
is not good.
Possible Cause
The door is not properly closed.
Poor connection to the power
supply.
Power failure.
Machine has not been switched on.
Machine safety protection is
working.
The detergent is not a low suds type. Check if the detergent is
Excessive use of detergent.
Not all transit bolts have been removed. Remove all transit bolts.
Washing machine is located on an
uneven surface or is not level.
Machine load is over 8 Kg.
Drain hose is blocked.
The filter is locked.
Drain hose end is higher than
100 cm above the floor.
Unbalance of the laundry.
Your Laundry was too dirty for the
programme you selected.
The amount of detergent used is
not appropriate.
Clothes exceeding the maximum
capacity have been filled in your
machine.
33
Possible Solutions
Close the door properly.
Check connection to the
power supply.
Check the power supply.
Switch the machine on.
Unplug the machine from
the mains socket.
appropriate.
Reduce amount of detergent
in the detergent drawer.
Make sure the washing
machine is set on an even
surface and levelled.
Reduce amount of laundry
in the drum.
Unblock the drain hose.
Unblock the filter.
Make sure the drain hose
end is lower than 100 cm
above the floor.
Add clothes or run a spinning
programme again.
Select a suitable programme.
Use more or less detergent,
following the manufaturer's
instructions.
Do not to exceed the
maximum capacity of your
machine.