Getting Started; Attaching The Hand Strap; Turning The Camera Off And On; Recharging The Battery - BenQ DC C25 User Manual

BenQ DC C25/C35 User's Manual

Attaching the Hand Strap

1. Run the small looped end of the hand strap through
the hand strap eyelet.
2. Bring the other end of the strap through the loop and
pull.

Turning the Camera Off and On

You can turn the camera off and on in two ways:
• Open and close the lens cover to turn the power on
and off (snapshot and movie mode only)
• Press and hold the power switch to turn the power on and off

Recharging the Battery

The DC C25/C35 is equipped with a built-in
rechargeable battery that can be recharged by
connecting the included AC power adapter or by
connecting the camera to a computer with the included
USB cable. Recharging takes about two hours.
The indicator LED glows orange when the battery is
charging. When the battery is charged, the indicator LED
turns off.
Warning: Use the adapter that came with your DC C25/
C35. Do not use other adapters.
Note: A minimum of 5 minutes charging time is required to regain minimal power of
the digital camera.

Using an SD Flash Memory Card

Inserting an SD Card
1. Turn the camera off.
2. Open the memory card compartment cover.
3. Insert the SD card into the slot until you
hear a click.
4. Close the compartment cover.
Removing an SD Card
1. Turn the camera off.
2. Open the memory card compartment cover.
3. Press down on the edge of the SD card. The card will spring up.
4. Gently grasp the card and pull it out. Close the compartment cover.
Note: If you are using an SD card in the DC C25/C35 for the first time, you must
format it. See page 16 to learn how to format the card.
G
ETTING
4
S
TARTED
USB