Table of Contents
Advertisement
C: Using the Keyfob
If a PCX-RIX32-WE (Enforcer wireless expander) is connected to the PCX 46, it is possible to learn up to 32
wireless 4 button keyfobs that may be programmed for specific functions: no action, show system status,
arm area, disarm area, operate user automation outputs and PA alarm activation. Please see the Installation
manual (RINS1605) for more information on installing a PCX-RIX32-WE.
Locking the Keyfob
All four buttons on the keyfob may be 'locked' to prevent from a user accidentally pressing them.
Locking the keys on the keyfob is performed by pressing any buttons that are diagonal with one another
at the same time (LOCK & II or UNLOCK & I).
The RED LED will flash indicating that the fob has been locked.
To unlock, press both buttons together again and the GREEN LED will flash indicating that the keyfob is
now unlocked.
NOTE: When the keyfob is locked, all indications are also disabled.
Buttons
The buttons can be customised to operate as desired (programmed in the function 'Learn User Codes, Keyfobs & Tags'). Below are examples on
how each button can be programmed:
BUTTON = Programmed for 'Arm Area' When pressed, one or more areas will be armed
BUTTON = Programmed for 'Disarm Area'. When pressed, one or more areas will disarmed.
I BUTTON = Programmed for 'User Output'. For example when pressed, a gate can be opened. When pressed again, a gate can be closed.
II BUTTON = Programmed for ''Status LED'. For example when pressed, the system status is shown' RED = Armed, GREEN = Disarmed, AMBER
= Fault.
+ I BUTTON = Programmed for "PA". When pressed a personal attack alarm will be generated.
Quick Arming
If one of the buttons is programmed as 'Arm Area', the alarm system can be armed by the keyfob. The keypad will then start to count down the
exit time (depending what the exit mode is programmed by the engineer). Once the alarm panel is in this 'arming' stage, it is possible to 'quick
arm' the system by pressing the same button again; this will reduce the time of arming and therefore making the system arm immediately.
The disarm LED on the keypad will turn off and a beep will be heard once the system has been armed and the RED LED on the keyfob will be
illuminated for a short time.
Timed: Make sure you leave the
building before the timer shown on the
keypad expires
Push to set: Press the push to set
button installed by your engineer to
arm the system
SETTING USING A WIRELESS KEY-FOB
To set via a key-fob. Press the
The key-fob LED will start to flash
GREEN indicating that the system is
starting to set
'Please wait arming wireless' will be
displayed on the keypad and the
programmed area will begin to set.
To 'quick set', press the
Once set, the key-fob LED will
illuminate RED indicating that the
system is now set
key
key again.
Page: 8
5
Advertisement
Table of Contents
