Table of Contents
Advertisement
PAUL station
manual
we recommend to place the valve close to the water filter
we recommend to place both valve and water filter close to the
ease maintenance (i.e. cleaning the filter from time to time, see chapter 6)
The hose clamps have to be fixed with a crimping tool or a gripper. They cannot be used mul-
tiple.
Please clean the RWT before you use it for the first time.
4.1.4
Remarks on the OPV or OPV-S
Usually the OPV/OPV-S is already mounted on
and use the hose nozzle of the OPV/OPV-S.
But if you upgrade an existing
®
on top of
PAUL
.
Instead, mount the OPV or OPV-S in the place the standard sieve has been; it might be a
good idea to store the sieve in a safe place.
Fixing the OPV or OPV-S with the two screws is very important as otherwise the OPV or
OPV-S in total will float when the water level is rising, and thus will not prevent
overfilling.
The OPV-S is equipped with a water level sensor that indicates if the water level falls below a
certain limit. This water level assures that a long term standstill is possible. The sensor in the
OPV-S must be connected by a very simple two line wire. At delivery, the connector is at-
tached to the sensor cable, and this connector has to be plugged into the LWS box that can
be seen in Figure 7.
PAUL Station Manual 2019-05-25
PAUL
®
PAUL
, then you will first have to remove the standard sieve
Figure 7:
LWS box
PAUL
®
so you can directly start assembly
page 11
®
unit as this will
®
PAUL
from
25.05.2019
Advertisement
Table of Contents
