Table of Contents
Advertisement
PAUL station
manual
4 Assembly
4.1 Set 1 to connect the Raw Water Tank with
4.1.1
Overview
Figure 3 shows how to connect all parts that come with set 1.
Figure 3:
On the left hand side the RWT connector can be seen. This connector comes pre-assembled
as can be seen in Figure 3.
Determine where to mount the filter. As this filter must be checked and – if necessary –
cleaned, see chapter 6.1.2, choose a location where the filter is easily accessible, see also
chapter 4.1.3. The valve is necessary to stop the water flow during filter cleaning, so the
valve should be mounted close to the filter.
Connect the RWT connector with the valve and then with the filter using the blue hose.
Finally, connect the filter with the OPV or OPV-S mounted in
4.1.2
Mounting the tank connector on the Raw Water Tank
It might be a good idea to execute this step before you put the RWT in place.
Figure 4 shows the two versions of RWT connector. Due to the different diameter, each com-
plete connector consists of different parts as can be seen from the figures and the list of parts
in chapter 9.
The wall of the RWT must be between the two seals.
As the connector comes pre-assembled, it has to be divided according to Figure 5.
Then, drill a hole in the RWT using the centre bit ¾" or 1", depending upon your tank connec-
tion diameter.
PAUL Station Manual 2019-05-25
All parts that come with set 1 and how to connect
®
PAUL
®
PAUL
using the blue hose.
page 8
25.05.2019
Advertisement
Table of Contents
