Installing The Batteries - Black+Decker BXAC40006GB Manual

Installing the Batteries

WARNING: Battery acid leakage can cause
personal injury and cause damage to the product
and surrounding property. If battery leakage occurs,
thoroughly wash any affected skin, making sure to
keep battery acid away from eyes, ears, nose and
mouth. Immediately wash any clothing or other
surface that comes in contact with leaked battery
acid. If a chemical burn occurs or if irritation persists,
seek medical attention. Dispose according to Local,
State or Federal regulations.
WARNING: NEVER mix old and new batteries or
different brands of batteries. Replace all batteries at
the same time.
NEVER mix alkaline, standard (carbon-zinc),
rechargeable (nickel-cadmium) batteries with this
product.
NEVER dispose of batteries in fire, as they may leak
and explode.
ALWAYS remove exhausted batteries from product.
Batteries are to be inserted following the polarity
markings on the product.
Remove batteries before extended storage.
♦
To begin using this air conditioning unit, start by
installing the batteries in the remote control.
♦
To install the batteries, first detach the battery
cover from the remote. To do this, place your
finger on the grooved area at the centre of the
battery cover and push down and away from the
body of the remote.
♦
Insert 2 x AAA batteries into the battery
compartment, taking care to ensure the polarities
are correct.
♦
Once the batteries have been correctly inserted,
replace the battery cover by aligning each of the
locking tabs with the corresponding notch on the
remote control body and pushing it upwards until it
clicks into place.
♦
The remote control is now ready for normal use.
(Original instructions)
Assembling Your 3-in-1 Air Conditioner
WARNING: Before performing any assembly or
maintenance, switch the unit off and remove it from
the power supply.
Installing the Window Hose
♦
Before using your air conditioning unit, you will
need to install the window hose so that hot air
from the appliance is released onto an outside,
open-air area. The sections below illustrate the
correct way to attach and install the window hose.
♦
Before using your air conditioner, you will need
to install the window hose so that fumes from the
appliance are released onto an outside, open-air
area.
♦
To install the window hose, feed the end of the
tube through any available window and secure it
into place using the included adaptor. Ensure the
distance between the unit and the window is at
least 50cm.
Note! When not using the air conditioner, plug the
hole with the cover provided.
ENGLISH
9