Draining The Unit; Setting The Timer - Black+Decker BXAC40006GB Manual

ENGLISH (Original instructions)
In cooling mode, the temperature will increase; in
fan mode, it will decrease.
Press the Sleep button again while the unit is in
sleep mode to turn this function off. The fan will
resume operation and default to the latest pre-set
mode and speed settings.
Note! In sleep mode, the unit will automatically turn
itself off after 12 hours of continuous operation.
The Timer Function
This unit is equipped with a 24-hour programmable
timer.

Setting the Timer

♦
Press the Timer button on the remote control or
on the appliance's control panel to activate the
timer. The number '0' will appear on the unit's LCD
display to indicate the timer function has been
selected.
♦
Once this function has been activated,
continuously press the Timer button again to
select your desired operation time, from 1 to 24
hours.
Pre-Setting the Timer
♦
The unit's timer can also be pre-set and used as
a delay timer, so that the unit will begin operation
after a set period of time.
♦
To pre-set a delay time, press the Timer button
while the unit is plugged into the mains, but not in
operation. The number '0' will appear on the unit's
LCD display to indicate the pre-set delay timer
function has been selected.
♦
Once this function has been activated,
continuously press the Timer button again to
select your desired delay time, from 1 to 24 hours.
Note! To cancel a pre-set delay timer, press the
Power On/Off button to turn the unit on, then press
the button again to turn it off if necessary. This will
cancel any previously set delay timers.
12

Draining the Unit

Water Hole Rubber Plug
While the unit is operating, water will be extracted
from the air into the built-in water tank.
When the reservoir is full, both the compressor and
motor will stop, the unit will emit a buzzing sound and
the 'Water' and 'Comp' indicator on the unit's control
panel will begin to flash.
When this occurs, we recommend you drain or
empty the water tank, to ensure the unit continues to
operate correctly.
To empty the water tank, follow the steps
below:
♦
Turn off the unit and avoid moving it.
♦
Place a container, such as a water tray,
underneath the drain hole.
♦
Remove the drain plug and plug cap, to allow the
water to drain out.
♦
When the container is almost full, place the drain
plug back into the plug hole and empty the water
tray.
♦
Repeat this procedure until the unit is empty.
♦
Once you have emptied the unit, put the rubber
plug and plug cap back into place and tighten the
cap firmly.
Draining
Knob