Advertisement
WARNING
• CARBON MONOXIDE HAZARD
• For outdoor use only. Never use inside house, or
other unventilated or enclosed areas. This heater
consumes air (oxygen). Do not use in unventilated or
enclosed areas to avoid endangering your life.
Caution: Do not attempt to operate until you have read and understand all General Safety
Information in this manual and all assembly is complete and leak checks have been performed.
Before Turning Gas Supply ON:
1. Your heater was designed and approved for outdoor use only. Do NOT use it inside a
building, garage, or any other enclosed area.
2. Make sure surrounding areas are free of combustible materials, gasoline, and other
flammable vapors or liquids.
3. Ensure that there is no obstruction to air ventilation. Be sure all gas connections are tight
and there are no leaks.
4. Be sure the cylinder cover is clear of debris. Be sure any component removed during
assembly or servicing is replaced and fastened prior to starting.
Before Lighting:
1. Heater should be thoroughly inspected before each use, and by a qualified service person at
least annually. If relighting a hot heater, always wait at least 5 minutes.
2. Inspect the hose assembly for evidence of excessive abrasion, cuts, or wear. Suspected areas
should be leak tested. If the hose leaks, it must be replaced prior to operation. Only use the
replacement hose assembly specified by manufacturer.
LIGHTING INSTRUCTIONS
Check and ensure that an AA battery is inside the ignition
chamber and has power.
Ensure the anode(+) faces outside.
1. Ensure that the control knob is OFF. Slowly open the
gas cylinder valve.
2. Press and turn the control knob to LIGHT position,
push the igniter to generate spark while keeping
control knob in pressed position
3. Check for pilot flame through glass tube. If pilot does not light, turn control knob to 'OFF'
position wait two minutes minimum and try again from the start. Several attempts may be
necessary.
14
OPERATION INSTRUCTIONS
Advertisement
