Related Manuals for Feig Electronic OBID i-scan ID ISC.ANT.UMUX
Summary of Contents for Feig Electronic OBID i-scan ID ISC.ANT.UMUX
- Page 1 APPLICATION-NOTE ID ISC.ANT.UMUX Firmware Update final public (B) 2011-05-10 N80301-1e-ID-B.doc...
- Page 2 Composition of the information in this manual has been done to the best of our knowledge. FEIG ELECTRONIC GmbH does not guarantee the correctness and completeness of the details given in this manual and may not be held liable for damages ensuing from incorrect or incomplete information. Since, despite all our efforts, errors may not be completely avoided, we are always grateful for your useful tips.
-
Page 3: Table Of Contents
2. The Update Step by Step 2.1. Detection of the Antenna Tuner ..................6 2.2. Selection of the new Firmware ..................7 2.3. Verifying of the Data ......................8 2.4. Start Update Process ....................... 9 FEIG ELECTRONIC GmbH Page 3 of 10 N80301-1e-ID-B.doc... - Page 4 Converter Figure 1: Connection to the PC The multiplexer board must be powered through the supply voltage connection X1 as it is done in the normal operation mode (see Installation Manual M71100-xde-ID-B). FEIG ELECTRONIC GmbH Page 4 of 10 N80301-1e-ID-B.doc...
-
Page 5: The Update Step By Step
If you have prepared the update as it is described above you can go on step by step with the OBID Firmware Update Tool. Therefor close any other running Windows programs on your PC and start the program by clicking “OBIDFirmwareUpdateTool.exe”. The program will guide you through the whole update procedure. FEIG ELECTRONIC GmbH Page 5 of 10 N80301-1e-ID-B.doc... -
Page 6: Detection Of The Antenna Tuner
2. Press the “Detect” button. The connected tuning board is displayed in the list. 3. Press the “Next” button. Note: By using a notebook or an USB to RS232 converter see application note for OBID Firm- ware Update Tool (N30300-2e-ID-B). FEIG ELECTRONIC GmbH Page 6 of 10 N80301-1e-ID-B.doc... -
Page 7: Selection Of The New Firmware
2.2. Selection of the new Firmware 1. Press the „Select Path...” button and chose the path were the new firmware is stored. 2. Mark the firmware in the list. 3. Press the “Next” button. FEIG ELECTRONIC GmbH Page 7 of 10 N80301-1e-ID-B.doc... -
Page 8: Verifying Of The Data
® OBID i-scan Application-Note ID ISC.ANT.UMUX 2.3. Verifying of the Data Check the information in the next window. If every data are OK press „Next“ button. FEIG ELECTRONIC GmbH Page 8 of 10 N80301-1e-ID-B.doc... -
Page 9: Start Update Process
Do not interrupt this process! In case of an error during the update process do not switch off the power supply of the multiplexer board. Restart the update process as offered by the Update Assistant. FEIG ELECTRONIC GmbH Page 9 of 10 N80301-1e-ID-B.doc... - Page 10 ® OBID i-scan Application-Note ID ISC.ANT.UMUX After receiving the message „Update successfully finished“ the tool can be closed by pressing the „Finish“ button. FEIG ELECTRONIC GmbH Page 10 of 10 N80301-1e-ID-B.doc...