Table of Contents
Advertisement
Detection Modes
Your EVO6000 supports four detection modes. The default mode is
In
motion mode
a short press on the
Another short press puts your EVO6000 back into motion mode.
A long press on the pin point button
puts your EVO6000 into
non-motion audio discrimination
EVO6000 into
non-motion single tone
motion
mode.
Motion Mode
Motion mode detects targets as they move relative to the detector head. Motion mode is good at
excluding ground signals and gives an accurate target ID. In motion mode you must swing the
detector as described in
Metal Detecting
the
pinpoint button
Pinpoint Mode
Pressing the
pinpoint button
Pinpoint mode is designed to help you precisely locate a target before you start digging. In pinpoint
mode you do not have to swing the search head. You can slowly move the search head around to
find the exact location of a target. In pinpoint mode the large numbers on the screen will show the
signal strength. The tone rises with signal strength as you get closer to the target. Move the search
head slowly over the target to find where your EVO600 has the highest number and tone.
Pressing the
pinpoint button
Non-Motion Audio Discrimination Mode
A long press on the
pinpoint button
audio discrimination mode.
Non-motion audio discrimination mode is designed to help you find deep targets on uneven or
overgrown sites where it is difficult to swing the detector. In non-motion audio discrimination mode
you do not have to sweep the search head. You can slowly move the search head around to find a
target. In non-motion audio discrimination mode the large numbers on the screen will show the
target ID. The pitch of the tone reflects the target ID of the target. Stronger signals will give louder
tones.The pitch and volume of the tone can be managed using the
and
discrimination volume
mode, if you find that the detector is disturbed by changes in ground conditions, use a short press on
the
pinpoint button
A long press on the
pinpoint button
EVO6000 into
non-motion single tone
Non-Motion Single Tone Mode
pinpoint button
steps through the non-motion modes. The first long press
mode. The third long press puts your EVO6000 back into
Technique. When you find a target you may wish to press
to switch to
pinpoint mode
in
motion mode
in pinpoint mode puts your EVO6000 back into
in
motion mode
and
master volume
settings. In non-motion audio discrimination
to reset the baseline level.
in non-motion audio discrimination mode puts your
mode.
21 / 32
motion
puts your EVO6000 into
mode. Another long press puts your
to help precisely locate the target.
puts your EVO6000 into pinpoint mode.
puts your EVO6000 into non-motion
iron
volume,
mode.
pinpoint
mode.
motion
mode.
discrimination level
Advertisement
Table of Contents
