Keypad - C-SCOPE EVO6000 User Manual

Keypad

Using The Keypad For Motion Mode Detecting
When you are detecting, the up and down buttons
the sensitivity down if you find that you are getting spurious signals or you want to ignore some of
the smaller deeper targets.
Using The Key Pad For Non-Motion Mode Detecting
A long press on the pinpoint button
discrimination mode. The pinpoint indicator on the screen will flash and the
animation on the screen will change. In the two
pinpoint button
resets the baseline level. You will need to reset the baseline level
when ground conditions change.
Press the pin point button to switch to and from pin point
mode.
Press the up or down buttons to adjust sensitivity.
Press the menu button to open the menus.
Press the OK button to start and stop the on screen animation.
will switch the EVO6000 to
Long press the pinpoint button to switch between detecting
modes.
Short press the pinpoint button to reset the baseline level.
Press the up or down buttons to adjust sensitivity.
Press the menu button to open the menus.
Press the OK button to start and stop the on screen animation.
16 / 32
adjust the sensitivity of your EVO6000. Turn
non-motion audio
non-motion detection modes the