Remote Control And Monitoring Via Diacom; Via A Lan Port; Via A Rs232/Rs485 Port - Delta DX-2100 Series User Manual

D X-2 100 Se ri es Ind ustr ia l 3G C lo ud Ro u ter
4.2.3
_4
4.2.3.1
If your router is connected to remote devices via a LAN port, you can use the
configuring/monitoring software on your local computer to configure and monitor after opening a
virtual tunnel. Some program would require the IP addresses of your remote device. Simply input
the required information in the configuring/monitoring software and then you can configure and
monitor the connected device remotely.
4.2.3.2
After opening a virtual tunnel, you will need to follow the setups below before using WPLSoft or
other configuring/monitoring software on your local computer to configure and monitor the
connected device remotely.
1. Click
router which is connected to your remote device on the search bar and then log in.
2. Go to the System setup page, select the setup option RS232 or RS485 and input the required
information to set up. Make sure the parameters are consistent with your remote device.


3. Go back to the DIACom and click
the virtual serial-port number will show up on the same page. Users can use it to configure
and monitor the connected device remotely. Click "Delete" to delete the virtual serial-port.
4 - 1 2
Notice

If the device's RS-232 / RS-485 is not operating in Transparent mode, the
corresponding button is grayed out.

DIACom will prompt an error message if the FW version of DX is under V1.3.3.

Remote Control and Monitoring via DIACom

Via a LAN Port

Via a RS232/RS485 Port

IP address in the DIACom device list
Working Mode：Transparent mode
Parameters of COM (Baud Rate, Data Bits, Stop Bits, Parity Bits, Flow Control)
or open a browser and input the IP address of the
to create a virtual tunnel. Once the creation is done,