Help - Motorola MBP855CONNECT User Manual

8. Help

Display
No display
• Try recharging or replacing the battery pack.
• Reset the Units. Unplug both the Units' electrical power, then plug them back
in.
• Is the Unit switched on?
Press and hold the ON/OFF button 0 on the Parent Unit for 3 seconds to
switch it ON.
• Is the correct camera selected? Change the camera number, if necessary.
• Is the video display turned on? Press the VIDEO ON/OFF button V to turn it
ON.
• When operating using batteries only, the display will go blank after 5 minutes
or 30 minutes or 60 minutes to save power (depending on video settings).
The Unit is still active and will give you audio alerts. You can reactivate the
screen by pressing any button.
Registration
If the Baby Unit has lost its link with the Parent Unit
• Try recharging or replacing the battery pack on both the Parent Unit and
Baby Unit.
• If the Baby Unit is too far away it may be going out of range, so move the
Baby Unit closer to the Parent Unit.
• Reset both the Parent Unit and Baby Unit by disconnecting them from the
electrical power. Wait about 15 seconds before reconnecting. Allow up to
one minute for the Baby Unit and the Parent Unit to synchronize.
• See 2.3 Registration (Pairing), if there is a need to re-register the Units.
Interference
Noise interference on your Parent Unit
• Your Baby and Parent Units may be too close. Move them further apart.
• Make sure there is at least 1 to 2m between the 2 Units to avoid audio
feedback.
Help 39