Intended Use; Foreseeable Misuse; Technical Data; Table - unicraft PG-I SE Series Operating Instructions Manual

Table of Contents

Advertisement

3

Intended Use

The generator is used exclusively to generate electricity.
It can be used universally for 230V consumers.
The Generator may only be operated by persons who
have been instructed on the machine.
Intended use also includes compliance with all informa-
tion in these instructions. Any use exceeding the inten-
ded use or any other use is considered misuse.
Stürmer Maschinen GmbH accepts no liability for design
and technical modifications to the generator. Claims of
any kind for damage due to improper use are excluded.

3.1 Foreseeable misuse

The following applications are prohibited:
- Use of waste heat for heating purposes
- Other use of the exhaust gases
4

Technical Data

4.1 Table

Model
PG-I 42 SE
Length
557 mm
Width / Depth
464 mm
Height
478 mm
Weight
42 kg
Drive motor
SV 230
Power max.
3,7 kW
Motor Power
5 PS
Fuel
Petrol
Tank capacity
15 l
Speed
3600 min¯¹
Sound pressure
76 dB(A)
level Lp
Sound power
96 dB(A)
level Lw
Nominal voltage
230 V
Continuous out-
3,8 kVA
put COP
Active power COP
3,8 kW
Max. voltage
4 %
deviation
Degree of protec-
IP 23M
tion (Generator)
PG-I SE Series | Version 1.04

4.2 Type plate

Fig. 2: Type plate Generator PG-I 42 SE
5
Delivery
After delivery, check the generator for visible transport
damage. If you find any damage to the generator, report
it immediately to the transport company or the dealer.
Transport
Only transport the generator with an empty fuel tank!
The spark plug connector must be disconnected.
PG-I 80 SE
730 mm
610 mm
Observe the weight of the machine during transport
730 mm
and lifting. The transport and lifting equipment must
be able to carry the load.
105 kg
SC 460
7,7 kW
10,5 PS
Protect the machine from humidity.
Petrol
The generator may only be transported standing up. During
25 l
transport, the generator must be well secured so that it
cannot tip over; drain the fuel and ensure that no acid or
3600 min¯¹
vapours escape from the battery (if any). For transport on
road vehicles, check the entire mass of the machine. Never
74 dB(A)
start the generator inside a vehicle.
94 dB(A)
230 V
For longer transports, make sure that the corrosion
7,0 kVA
protection is intact or renewed if necessary.
Transport with a forklift/lift truck:
7,0 kW
For transport with a sufficiently dimensioned lift truck or
4 %
forklift truck, the generator must stand upright and secu-
red against falling over on a level, firm surface (e.g. on a
pallet).
IP 23M

Transport, packaging, storage

ATTENTION!
NOTE!
NOTE!
Tips and recommendations
Intended Use
7

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Pg-i 42 sePg-i 80 se67064206706800

Table of Contents