Safety Labels On The Generator - unicraft PG-I SE Series Operating Instructions Manual

Safety
- Do not misuse the machine for other purposes, such
as: heating a room with the heat emitted by the mo-
tor, etc.
- DO NOT attempt to start a damaged generator.
Make sure that the fuel filler cap, air filter, spark
plug, fuel lines and exhaust system are in good con-
dition.
- When starting the motor, slowly pull the starter ca-
ble until resistance is noticeable and then pull quic-
kly to avoid kickback. DO NOT start or stop the mo-
tor when electrical equipment is connected.
- When the device is not in use, unauthorized access
must be prevented; therefore equip the generator
with blocking systems (remove the ignition key, lock
the protection cover with appropriate locks, etc.).
- DO NOT overload the generator.
- Make sure that the cooling slots are not blocked. If
connected devices overheat, turn them off and
disconnect them from the generator.
- Do not remove any guards and do not leave the ma-
chine running without suitable protection (sides and
housing) so as not to expose the user to danger.
- Do not remove any protective devices and do not
run the machine without suitable protection (sides
and housing) to avoid exposing the user to danger.
- NEVER use this device to power medical equip-
ment.
- When servicing the generator: disconnect the igni-
tion cable and place it in a place where it cannot
touch the plug. Use only approved spark plug te-
sters.
- Do not run the machine in rooms with a potentially
explosive atmosphere.
- In an emergency, do not use water to extinguish fi-
res, only special safety systems (powder fire extin-
guishers, etc.).
- If it is necessary to work near the machine, it is
necessary to use hearing protection (headphones,
ear protectors, etc.).
- When transporting or servicing the generator: Make
sure the fuel shut-off valve is off and the fuel tank is
empty. Disconnect spark plugs !
ATTENTION!
Avoid direct physical contact with fuel, engine oil and
battery acid. In case of skin contact, wash with water
and soap and rinse thoroughly: do not use organic
solvents. In case of eye contact, wash with water and
rinse thoroughly. If these liquids are inhaled or
swallowed, consult a doctor immediately.
6

2.6 Safety labels on the generator

The following safety labels and instructions are attached
to the generator (Fig. 1) and must be observed.
PG_I 80 SE
Fig. 1: Safety labels PG-I 42 SE and PG-I 80 SE
The safety labels attached to the machine must not be
removed. Damaged or missing safety labels can lead to
incorrect actions, personal injury and damage to pro-
perty. They must be replaced immediately.If the safety
markings are not recognisable and understandable at
first glance, the machine must be taken out of operation
until new safety markings have been applied.
PG-I SE Series | Version 1.04