Control Elements And Functions; Pg-I 80 Se - unicraft PG-I SE Series Operating Instructions Manual

7 Control elements and functi-
ons

7.1 PG-I 80 SE

Connection for consumers (sockets)
The receiver can be used to operate corresponding de-
vices such as electrical lighting or tools.
Air Filter
The air filters help to limit the amount of dirt and dust that
is sucked into the unit during operation.
ECO-Button
The ECO button controls the engine speed and saves
fuel. When the switch is in the ON (I) position and no
equipment is connected to the appliance, the engine
runs at idle. When a device is added, the engine speed
increases to power the item. When the unit is removed,
the engine returns to idle.
NOTE!
If high electrical loads are connected simultaneously,
turn off the ECO switch to reduce voltage changes.
Fuel tank
Before operation, start with a full tank to increase the
operating time. Always refuel with the engine switched
off and cooled down.
Fuel gauge
The fuel gauge is a mechanical device that measures the
fuel level in the tank. The red indicator in the window in-
dicates the fuel level in relation to full or empty.
Ground terminal
The ground terminal is used to assist in properly groun-
ding the generator to help protect against electrical
shock. Consult with a local electrician for grounding re-
quirements in your area.
LED display
LEDs indicate when the generator is running, overloaded
or in need of lubricant.
PG-I SE Series | Version 1.04

Control elements and functions

NOTE!
The overload indicator may also turn on for a few
seconds when electrical loads requiring a high star-
ting current have been connected, e.g. Compressors,
pumps or refrigeration units. In this case, there is no
interference.
Oil indicator light (red):
As the motor oil level drops below the required minimum
level, this light switches on and the motor stops automa-
tically. The engine cannot be restarted until oil has been
refilled and the correct level has been reached.
NOTE!
If the oil light flashes during starting and the engine
does not start, oil must be refilled before a new start
attempt.
Only operate the generator on flat surfaces! An une-
ven position of the generator can lead to activation of
the engine oil protectio
Motor ON/OFF switch
In to start the generator, the switch must be set to "I". If
the switch is set to "O", the motor is stopped and cannot
be started.
Parallel connector between 2 generators
The parallel connection of two generators enables a cor-
respondingly increased power consumption of the
connected loads.
Wire rope hoist
Used when the battery voltage is too low to start the star-
ter motor. Pull the wire rope to start the generator engine
manually.
12V output
The 12V output is used to charge batteries. To charge
batteries, please follow the battery manufacturer's in-
structions.
Multi-Switch
The multi-switch is used to control fuel and choke. When
storing the generator, the multiswitch must be switched
to the OFF position.
Petrol cock
The fuel cock controls the flow of fuel from the tank to the
carburetor. The valve knob must be set to "I" to start and
operate the generator. Set the fuel tap to "O" when the
engine is switched off and the generator is stored or
transported.
11