Removing The Door - Whirlpool ACM 875 Instructions For Use Manual

Removing the side grids (depending on models)
Grip the bottom part of the side grids and pull towards the middle
of the oven. Lift upwards to completely remove.
Pull the side grid as shown in the picture (fig. 1). After releasing it
from clips, lift up.
Carry out the above steps in reverse order to refit the side grid.
Caution: After cleaning, be sure that the grids are fitted in their
original sides. The notches on the grids must be close to the front,
not rear.

Removing the door

Caution: When carrying out the following operations it is
advisable to wear protective gloves. Carefully follow these
instructions to prevent injury and/or damage to the oven
door and hinges.
Pay attention to the oven door hinges: risk of injuring
hands!
Open the oven door
Fully open the saddle brackets
While opening the saddle brackets, use a metal tool such as
handle side of a spoon for easy opening.
Close the door almost completely (Fig. 3), and remove by pulling
it outwards.
NOTE: Proceed in reverse order to refit the door. Make sure the
saddle brackets are lowered before closing the oven door.
Replacing the rear oven lamp:
1. Disconnect the oven from the power supply.
2. After the oven has cooled down, unscrew (anticlockwise) the
lamp cover A (Fig. 4).
3. Replace the lamp (see note).
4. Refit the lamp cover.
5. Reconnect the oven to the power supply.
Note: Only use 25 W/230 V E-14 type T300°C lamps
available from the After-Sales Service.
Important: Do not use the oven until the lamp cover has
been refitted.
74
DETAIL A
saddle
bracket
saddle
bracket
(see detail A)
Fig. 2
Fig. 3
Fig. 4
Fig. 1