Table of Contents
Advertisement
Available languages
Available languages
Leveling of appliance
For sufficient leveling and air circulating in the lower rear section of the
appliance, the bottom feet may need to be adjusted. You can adjust
them manually by hand or by using a suitable spanner.
To allow the doors to self-close, tilt the top
backwards by about 10mm.
Stand your appliance in a dry place to avoid
high moisture.
Keep the appliance out of direct sunlight, rain
or frost. Stand the appliance away from heat
sources such as stoves, fires or heaters.
lnstalling the door handles
For the convenience of transportation, the door handles are separately
provided in a plastic bag, you can install the door handles as follows.
1
Lever screw covers on the right side of the door, and then put them
back to the plastic bag.
2
Match the handle on the right side of the door, keeping axes of
screw holes in the handle and the door in a line, as the picture
shows.
3
Fix the handle with the special screws provided in the plastic bag.
And then install the handle covers.
Reversing the door
The side at which the door opens can be changed, from the lefl side (as
supplied) to the right side, if the installation sile requires.
Warning! When reversing the door, the appliance must not be con-
nected to the mains. Ensure that the plug is removed from the mains
socket.
Tools you will need:
•
8 mm socket wrench
•
Cross headed screwdriver
•
Small thin blade screwdriver
•
8 mm wrench
Note: Before you start lay the refrigerator on its back in arder to gain
access to the base, you should rest it on saft foam packaging or similar
material to avoid damaging the backboard of the refrigerator. To re-
verse the door, the foliowing steps are generally recommended.
1
Stand the refrigerator upright.
2
Open part (1) on top of the refrigerator body from left side and then
take down part (3) and part (4) on the door in the same way. Take
down part(2) put it back to the plastic bag.
°
°
3
Disconnect electrical connector (1) as well as electrical con- nector
(2) and then take down part (3).
4
Remove the screws (1), loose wire (2), and remove part (3).
Note: Please hold the door by hand during step 4 to prevent door
dropping.
5
Remove the door and place it on a smooth surface with its panel
upwards. Lever part (1) and part (4), then loose screws (2), as
shown in the picture. Change handle (3) to the left side, then install
screws (2), part (1) and part (4) in turn. Loose screws (7), detach
part (6) and part (5), turn part (6) over and then install part (5) and
part (6) to the right side with screws (7).
Advertisement
Table of Contents
