Safety Warnings; General Warnings; Power Supply - Javad TRE Application Notes

Appendix

Safety Warnings

• Read these instructions.
• Keep these instructions.
• Heed all warnings.
• Follow all instructions.
• Clean only with a damp cloth.
• Install in accordance with the manufacturer's in-
structions.
• Do not install near any heat sources such as radi-
ators, heat registers, stoves, or other apparatus (in-
cluding amplifiers) that produce heat.
• Protect the power cord from being walked on or
pinched particularly at plugs, convenience recepta-
cles, and the point where they exit from the appa-
ratus.
• Only use attachments/accessories specified by
the manufacturer.
• Unplug this apparatus during lightning storms or
when unused for long periods of time.
• Refer all servicing to qualified service personnel.
Servicing is required when the apparatus has been
damaged in any way, such as power-supply cord or
plug is damaged, liquid has been spilled or objects
have fallen into the apparatus, or has been dropped.
• Apparatus shall not be exposed to dripping or
splashing and no objects filled with liquids, shall be
placed on the apparatus.

General Warnings

This product should never be used:
• Without the user thoroughly understanding oper-
ator's manual.
• After disabling safety systems or altering the prod-
uct.
• With unauthorized accessories.
• Contrary to applicable laws, rules, and regula-
tions.
Warning: THE EVALUATOION KIT SHOULD NEVER BE USED IN
DANGEROUS ENVIRONMENTS.
10

Power Supply

Connect the supplied adapter to the side of the unit
in the slot marked "PWR". Plug the two-prong end of
the power cord to an AC100-240V outlet. If you have
difficulty inserting the plug, turn it over and reinsert it.
If the unit will not the used for a long time, disconnect
the plug from the outlet.
Before plugging the power cord into an AC outlet,
Note:
make sure that all the connections have been made.
CAUTION: To reduce the risk of electric shock, do not perform any
servicing other than that contained in the operating instructions
unless you are qualified to do so.
CAUTION: To avoid the introduction of hazards when operating
and installing, before connecting of the equipment to the sup-
ply, make sure that the supply meets local and national safety
ordi- nances and matches the equipment's voltage and current
requirements.
CAUTION: Never attempt any maintenance or cleaning of the sup-
ply while plugged in. Always remove supply from AC power before
attempting service or cleaning.
CAUTION: If the voltage supplied is below the minimum specifi-
cation, the TRE/TR Evaluation Kit will suspend operation. If the
voltage supplied is above the maximum specification, the TRE/
TR Evaluation Kit may be permanently damaged, voiding your
warranty.
Make sure cords are located so that will not be stepped
on, tripped over, or otherwise subjected to damage
or stress. Do not operate equipment with a damaged
cord or plug – replace immediately. To reduce the risk
of damage to the equipment, pull by the plug body
rather than the output cord when disconnecting the
equipment. Do not operate the supply if it has received
a sharp blow, been dropped, or otherwise damaged.
Do not disassemble the supply.
CAUTION: Before connecting the external power source and the
TRE/TR Evaluation Kit, make sure that the power source matches
the TRE/TR Evaluation Kit's voltage and current requirements.
www.javad.com