Assemble Shock And Relief Valves, And Dust Seal, To Housing - Danfoss VSPP Service Manual

Service Manual
VSPP Steering unit
VSPP assembly

Assemble shock and relief valves, and dust seal, to housing

© Danfoss | November 2019
6. Screw in the plug (25) using a 22mm socket spanner.
O-ring (25.2) is fitted to the plug.
Tightening torque: 40 ± 10 N•m [354 ± 88 lbf•in]
7. Insert the cone (85).
8. Insert the spring (86).
9. Screw in the screw (87) using an 8mm Hex key.
O-ring (87.2) is fitted to the screw.
Tightening torque: 20 ± 5 N•m [177 ± 44 lbf•in]
To assemble shock and relief valve parts to the column end of the housing, follow these steps.
Place the unit on the holding tool on the gear set end.
VSPP placed on mounting tool - gear set end
AX319758618681en-000101 | 29